A possible expansion card failure has occurred. Reseat the memory modules. Unexpected interrupt in protected mode. If available, install properly working memory of the same type into your computer. Serial or parallel port test failure. Master DMA register failure. Master interrupt mask register failure.
|Date Added:||24 December 2008|
|File Size:||23.23 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
A possible floppy or hard drive failure has occurred. Memory modules are detected, but a memory failure has occurred. The hard drive is not working or is not configured correctly. To help you troubleshoot a problem, your computer is equipped with four lights on the back panel labeled “A,” “B,” “C,” and “D.
If available, install properly working memory of the same type into your computer. Viideo interrupt in protected mode. Reseat all power and data cables and restart the computer. Your computer might emit a series of beeps during start-up vireo the monitor cannot display errors or problems. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board.
Dell Dimension C Specs – CNET
An interrupt channel on the system board failed to POST. Video Memory Test failure. Master interrupt mask register failure. One possible beep code code consists of one beep, a burst of three beeps, and then one beep. Repeat this process for each card. If the problem persists, reinstall the card that you removed, remove a different card, and then restart the computer.
Memory failure above address 0FFFFh. If the problem persists or the computer has integrated video, see “Contacting Dell” in vieeo Owner’s Manual.
Continue until you have identified vidoe faulty module or reinstalled all modules without error. If you hear one of the following beep codes, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. An error occurred with the keyboard connector.
Ensure that the drive is installed correctly in the computer and defined correctly in the system setup program.
If the problem persists, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. If the computer starts normally, move the memory module to a different connector and restart the computer. The operating system cannot be located on drive A or drive C.
If the message you received is not listed in the table, see the documentation for either the operating system or the program that was running when the message appeared. A possible expansion card failure has dimensino.
An error is occurring on the timer on the system board. If the problem still exists, install a video card that you know works and restart the computer. Search for video ROM failure. Determine if a conflict exists by removing a card and then restarting the computer.
If the computer has a video card, remove the card and reinstall itand restart the computer. The BIOS cannot communicate with the floppy drive or hard drive controller.
The system configuration information in the system setup program is incorrect or the battery charge 460c0 be low. Error in the DMA controller on the system board.
Continue until you have identified a faulty dimensino or reinstalled all modules without error. Reinstall all memory modules and restart the computer.
See “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance.