Wait until the carriage is idle and silent before continuing. Hold them both down for 2 or 3 seconds. All the lights are blinking In this error condition , all of the control panel lights are blinking:. Please try again shortly. Modify your browser’s settings to allow Javascript to execute. If you have a defective cartridge or printhead, it might be under warranty.

Uploader: Galkis
Date Added: 24 February 2015
File Size: 24.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 65292
Price: Free* [*Free Regsitration Required]

Remove the new ink cartridge from its packaging, and then deskjeet the orange tab to remove the plastic tape. Make the preferred The Virtual Agent is currently unavailable.

How to print a test page Follow these steps to print a test page. Plug the power cord directly into a wall outlet. Follow these steps to install the software. Please enter a Product Number to complete the request. One or both cartridge lights are on In this error conditionthe following control panel light pattern displays:. Voltage and amperage requirements on up HP printer. Check the electrical outlet to make sure that the power cord is plugged in securely.

First, press the power button on the printer device to Power Off and proceed to the steps below for rectifying this 5246r. If the issue persistscontinue to the next solution. Tri-color ink cartridge light is on.


HP DeskJet 2546R All-in-One Printer

If the test page deskmet not printcontinue with the next solution. Wipe the contacts with a dry swab or other lint-free material until no debris remains on them. Make sure the carriage can move freely across the width of the printer. This product was sold by a third party. If you were not scanning when the error occurred, continue to Service the printer at the end of this document. If the indicator light is oncontinue to the next step.

– HP DeskJet R All-in-One Printer SW Download

If the printer uses a power module with a detachable power cord, disconnect the cord from the power module. Reconnect the power cord and any cables to the rear of the printer, and then turn on the printer. The measurements were taken with the paper trays retracted.

Clear any jammed paper from the output tray Follow these steps to clear the jam from the output tray.

Make sure that the ink cartridge is not left out of the printer for more than 30 minutes. When an indicator shows low ink levels, consider having a replacement ink cartridge available to avoid possible printing delays. Clean the ink cartridges one at a time.


If you press and hold the Power button too long, the printer might turn on and then off without restarting. Check the connection and turn on the device. Deskhet sure that the power cord is connected to the rear of the printer and directly into a wall outlet. This page requires Javascript.

The HP Deskjet r Printer can sometimes malfunction due to any technical glitches or errors. Print a test page Print a test page to make sure that the hardware functions correctly. Press the Power button to turn on the printer, if it is not already turned on.

HP DeskJet R All-in-One Printer | HP® Customer Support

Connect the devices to the same network. While holding down the Power button, press and hold the Cancel button. Dims and then brightens. Xeskjet has scanned your product but currently has no suggestions for driver updates.